Wall Panels & Marbleflex
Wall Panels have a uniform smooth surface. This is due to the composition
that makes up the abestos-free fibre cement sheets. The natural
colour of the panels are light rey but can be painted with any water
based emulsion or acrylic to give the desired finish.
Due to its composition, it is not affected by insects, termites,
sunlight or steam. It will not rot or split. It is also weather
The asbestos-free fibre cement material of the wall panels have
(a) Early Fire Hazard Indices as tested to AS 1530 Part 3 - 1982
|Frame Spread Index
|Heat Evolved Index
|Smoke Developed Index
(b) Uniform Building By Laws 1984 Class "0"
(c) BS 476 Part 6 (fire propagation)
Index Performance (l) = 1.1 to 2.8
Sub-Index (i) = 0.2 to 1.6
(d) BS 476 Part 7 (surface spread of flame)
Characteristics - Class (1)
The sandwich panel is non-flammable, water resitant,
non-corrosive, anti-acid, non-rusting and non-rotting.
It is extremely resilient. It does not warp or bend even when exposed
to heat or moisture.
It can be cut or sawn using a tungsten carbide-tipped power circular
- It can be easily installed with speed at job sites by unskilled
- It is economical to use.
- It can be be completed easily to meet stipulated deadlines.
- It is versatile and can be made to suit building plans.
- It is available immediately.
- It requires only minimal maintenance.
||8' (All patterns)
9' & 10' (Superflex, Stucco, Tika & Chemerah only)
Marbleflek is a one-pack decorative multi-colour coating suitable
for interior use on almost any surfaces where attractive hard wearing
decoration is required.
Marbleflek is available from a virtually limitless range of colours
and can be colour-matched to any brand of multi-colour from any
Marbleflex is ideally suited for use in high traffic areas: Hotels,
Resorts, Schools, Hospitals, Offices, Shopping Malls, Airports,
Surface should be clean, dry and free from loose or flaking
materials. Apply a coat of Marbleflek Basecoat prior to applying
Marbleflek Multi Colour.
Approximately 4 square metres per litre depending upon
pattern type and substrates surface texture.
Supplied ready to use. Apply by spray only. Spray apply
using the cross lap method of application, ventilate during application
and drying period. For best results, use spray gun fitted with medium/large
internal mix spray cap connected to pressure pot. Pressure should
not fluctuate during application so as to ensure consistency of
spraying. If thinning is required 5% water should be added gradually
in small increments.
Marbleflex Glaze Coat may b applied as an additional
top coat for a glossy and extra protective finish.
Marbleflek can be applied on Dry Walls, Fibreboard, masonry,
Plaster Walls, Gypsum baords, Brick and Cement Walls, Acoustical
Tiles, Wood, Fibreglass, Plastic, Glass and almost all building
Marbleflek is anti-static and does not atttract airborne dust,
thus reducing maintenance costs.
- Fast Drying
- Tough & Durable
- Hides surfaces imperfections
- Can be touched up
- Attractive and cheaper than wallpaper.
Surface dry in 3 hours, hard dry, overnight. Do not apply
when humidity is high enough to cause surface condensation o when
temperature may fall below 5° C.
5 Litre can. 20 Litre Drum.
Click to view in detail